FAQ’s

FAQs on linksyssmartwifi.com

Linksys smart wifi router’s web based management page can be accessed either locally or remotely. The remote access allows you to manage the router through a remote location making use of the internet connection. This allows Linksys smart wifi login using linksyssmartwifi.com in the Address bar followed by entering linksys smart wifi password and username default settings. This requires Linksys smart wifi router to be setup beforehand.

The default Linksys smart wifi router password for all the Linksys Smart Wi-Fi Routers is admin. However, it is always advised to personalize your Linksys router default password to ensure that the Linksys smart wifi is safe from any kind of unauthorized access.

Some technical glitches might cause Linksys smart wifi not working error. If you are unable to connect to the internet, try to power cycle you router. You must power OFF your Linksys smart wifi router by unplugging the power cord and then power it on again. Simply power cycling the router can help resolve small issues. If no try to check if your router’s firmware has been upgraded or your Linksyssmartwifi.com setup has properly configure your wireless settings.

To Change your Linksys smart wifi router’s Wi-F/wireless password, access the web interface setup page through “192.168.1.1”or linksyssmartwifi.com login. Access its Wireless settings to change the wifi password in the Passphrase field by creating a new one.

The Linksys smart wifi router’s login default local IP address or the Default Gateway is 192.168. 1.1.

Confirm that your Linksys wifi range extender is connected to the wireless network. If this doesn’t help, Disconnect and then reconnect the linksys wifi range extender to the power source.

A factory reset on any router can return the router’s settings to default values; therefore, probably you lost the credentials to log into the router needed to connect to the ISP. If this is the case, you will have to perform linksyssmartwifi.com setup and allow configuration again to wireless network. You will then have to re-enter the wireless network username and password login.

This is because your internet provider changes Linksys smart wifi login IP address too often, and your router doesn’t get connected to it. Or your linksys router might be overheating or getting bogged down by too many wireless devices connections at once.

The blinking orange LED behaviour on Linksys wifi extender indicates problem with linksyssmartwifi not working. To check this, ensure that your router has an active internet connection and its Wi-Fi connection is on. Try to unplug the wireless range extender and position it closer to the linksys router. Turn it on back again and wait till it reconnects to your network.

The default username and password is admin. It is required to log into the Linksys wireless range extender’s dashboard to manage and configure it settings.